Loading... Please wait...

Knowledge Base - brakes

My motorcycle’s brake light wiring is only a two (2) wire system (power and ground), and the power wire is also doubles as my running light source. Do any of your BackOFF modules work with my brake light setup?

Posted

For that particular brake wiring setup, our BackOFF modules can work, but you would have to wire the BackOFF module to the brake SWITCH wire instead of the brake light wire. The brake light wiring is considered a “variable voltage system” in which partial power is sent through the brake wire to act as a running light. When signal is sent from the brake switches, full power is sent through brake wire. Our BackOFF modules require a dedicated 12V on/off source of power to function properly. This setup is commonly found on Victory motorcycles (as well as some British motorcycles and Japanese motorcycles).

Are flashing brake light(s) technically “legal”?

Most (if not all) State motorcycle handbooks recommend that you pump your brakes to flash your brakes to increase rear end visibility while coming to a stop. Our BackOFF brake light modules automates this recommendation for you while you're stopped or stopping. Our BackOFF brake light modules automatically facilitate compliance with these State handbooks, and enhance safety and rear end [...]

Read More »


Will the Original BackOFF Brake Light Module, Part Number 01001, work with LED brake light(s)?

We normally recommend our BackOFF XP Brake Light Module, Part Number 01004, instead for motorcycles with LED brake light(s). The BackOFF XP module works with both LED lighting or standard incandescent bulb(s), or a combination of both type of lighting. Because LED(s) draw less of a “load” of power through the system, our Original BackOFF Brake Light Module may [...]

Read More »